Différences

Ci-dessous, les différences entre deux révisions de la page.

--- sunfluidh:inlet_outlet_boundary_conditions_examples [2016/11/28 17:32] – yann
+++ sunfluidh:inlet_outlet_boundary_conditions_examples [2018/12/15 14:56] (Version actuelle) – [Example of inflow/outflow boundary conditions] yann
@@ Ligne 1: / Ligne 1: @@
 ===== Example of inflow/outflow boundary conditions =====
+[[sunfluidh:inlet_boundary_conditions_setup_namelist|Click here for the previous page on the inlet boundary conditions]] \\
+[[sunfluidh:outlet_boundary_conditions_setup_namelist|Click here for the previous page on the outlet boundary conditions]] \\
 <WRAP info>
    * This example is defined for a 2D geometrical configuration. The size of the domain is $1.5 \times 1.0.$
    * The flow is homogeneous (no multi-species gas)
-   * An inlet is located at the down left side of the domain.
+   * An inlet is located at the down left side of the domain (red line on the figure).
-   * An outlet is located at the top right side of the domain.
+   * An outlet is located at the top right side of the domain (green line on the figure).
    * Conditions are constant in time
 </WRAP>
 {{ :sunfluidh:inflow_outflow_bc.jpg?direct&600 |}}
+(inlet in red line, outlet in green line, remaining walls in blue lines)
@@ Ligne 77: / Ligne 79: @@
 ==== Example 2 ====
-__** Not for the release SUNFLUISH_EDU**__
+__** Not for the release SUNFLUIDH_EDU**__
 <WRAP info>
@@ Ligne 93: / Ligne 95: @@
    Pressure_Reference_Value       = 0.0    , Length_Scale= 0.2 ,
    End_of_Data_Block= .true. /
+[[sunfluidh:inlet_boundary_conditions_setup_namelist|Click here for the previous page on the inlet boundary conditions]] \\
+[[sunfluidh:outlet_boundary_conditions_setup_namelist|Click here for the previous page on the outlet boundary conditions]]