Différences

Ci-dessous, les différences entre deux révisions de la page.

--- sunfluidh:probe_location_setup_namelist [2017/02/21 10:30] – [Full data set of the namelist] witko
+++ sunfluidh:probe_location_setup_namelist [2022/01/10 12:21] (Version actuelle) – yann
@@ Ligne 7: / Ligne 7: @@
    &Probe_Location  Xi=-0.50 , Xj= 0.0 , Xk= 0.0 /
    &Probe_Location  Xi=-0.70 , Xj= 0.2 , Xk= 0.0 /
-   &Probe_Location  Xi=-0.80 , Xj= 0.03, Xk= 0.4 , End_of_Data_Block= .true./
+   &Probe_Location  Xi=-0.80 , Xj= 0.03, Xk= 0.4 /
 <note important>
       * You also need to set the quantities you want to monitor in the namelist "Probe_Quantities_Enabled" and the field Probe_Recording_Rate in the namelist "Simulation_Management"
       * The coordinates are related to the geometry chosen (cartesian or cylindrical configuration, see the namelist "Geometric_Layout").
-      * Don't forget to set the boolean data “End_of_Data_Block” at the end of the namelist. The value is ".false." by default. A “.true.” value means the end of the data set when several namelists are used to define several probe's location.
+      * The number of probes is limited at 1000 by default on the whole computational domain. When the simulation is performed with a MPI domain decomposition approach, this limit is valid for each MPI subdomain.
 </note>
 -----
@@ Ligne 28: / Ligne 27: @@
    * Type : Real value
    * Coordinate of the probe along the K-direction.
-==== End_of_Data_Block ====
-   * Type: Boolean value
-   * This means the end of the data set when ".true." is set.