Différences

Ci-dessous, les différences entre deux révisions de la page.

--- sunfluidh:velocity_wall_boundary_condition_setup_namelist [2017/10/02 14:30] – yann
+++ sunfluidh:velocity_wall_boundary_condition_setup_namelist [2017/10/02 14:32] (Version actuelle) – yann
@@ Ligne 45: / Ligne 45: @@
     West_Wall_Velocity_K= 0.0    , East_Wall_Velocity_K= 0.0   ,
     Back_Wall_Velocity_K= 0.0    , Front_Wall_Velocity_K= 0.0    ,
-    South_Wall_Velocity_K= 0.0   , North_Wall_Velocity_K= 0.0 ,
+    South_Wall_Velocity_K= 0.0   , North_Wall_Velocity_K= 0.0 /
-    End_of_Data_Block= .true.   /
 <note important>
    * The data linked to the velocity components contain the character string "Velocity_I", "Velocity_J" or "Velocity_K". These data are thus applied to the velocity component along the I,J or K-direction, respectively.
-   * When `__**the usual no-slip and impermeability conditions are applied for all walls**__, this namelist could be omitted in the data file. The code use this boundary condition by default for any wall.
+   * When __**the usual no-slip and impermeability conditions are applied for all walls**__, this namelist could be omitted in the data file. The code use this boundary condition by default for any wall.
    *This namelist can be pooled with other ones of same type (for the heat or species mass fraction) to form a full wall boundary condition setup.